ELECTRONIC & ENGINEERING CO. (I) P. LTD.
25
May
Share
No Comments on Automated 100% Crack & Heat Treatment Testing of Gear Shafts EECI Blogs
Automated 100% Crack & Heat Treatment Testing of Gear Shafts
The gear shaft is a central component of the transmission. The constant load changes stress the component to a high degree, which is why perfect material is necessary. Foerster assists in quality assurance with non-destructive testing systems, that use the eddy current method to check the gear shafts for material defects such as cracks, as well[…]
Read More02
Feb
Share
No Comments on CAST SWASH PLATE INSPECTION OF AUTOMOBILE AIR-CONDITIONER COMPRESSOR EECI Blogs
CAST SWASH PLATE INSPECTION OF AUTOMOBILE AIR-CONDITIONER COMPRESSOR
Every automobile is equipped with an air conditioner, and there is a compressor between the heat exchanger of the indoor unit and the heat exchanger of the outdoor unit. The power of the compressor is transmitted from the power shaft of the reciprocating engine by a belt. However, in the special environment of an automobile,[…]
Read More23
Dec
Share
Comments Off on MICROSTRUCTURE & CRACK TESTING OF ROTOR SHAFTS USING EDDY CURRENT EECI Blogs
MICROSTRUCTURE & CRACK TESTING OF ROTOR SHAFTS USING EDDY CURRENT
As a central component of electric motors, rotor shafts ensure the torque transfer from electrical energy to kinetic energy. Without the rotor shaft, an electric vehicle would not move. Withstanding very high loads requires high strength and sophisticated components. Non-destructive eddy current testing is suitable for detecting material and microstructural defects before they make it[…]
Read More